by Paul Behrends | Dec 26, 2021 | Windmill Service
Last summer we installed this D702 pumping Aermotor with this 2500gal. water tower. It provides water for Long-horn cattle. The 2500gal poly tank is wrapped with a wooden (cedar) sleeve for ascetics only. The 3″ closed top cylinder is at 63′. The tower...
by Paul Behrends | Feb 8, 2021 | Windmill Service
I recently repaired this 8×60 3-post pumping Aermotor. Windmill pumps for household use. Feb 3, 2021.
by Paul Behrends | Feb 8, 2021 | Windmill Service
I recently rebuilt this 1930’s 8′ “New Elgin” model R near Union, IL. The pump used was Hitzer 50ASP with 2-1/2″ cylinder. It will be used for watering cattle in the near future. Had to use my Gin pole to raise the mill due to...
by Paul Behrends | Feb 8, 2021 | Windmill Service
Storm ravaged B702 replaced with newly rebuilt B702 in coastal south GA. The 10′ mill shown here with 7′ stub (top section of 60′ twr.). Even the good old galvanized Aermotor bolts were seized tight due to the salt air. December 3, 2020.
by Paul Behrends | Feb 8, 2021 | Windmill Service
December 1, 2020 I travelled to Monroe GA to install this pumping A702 x 33 Aermotor. Water is for a matched pulling mule team.
